Refer to the TSP Wiring Connections and Fig. Route and terminate component cables to the TSP60 through the opening on the rear housing.Mount the TSP60 over all three screw heads until flush against the wall, then slide down onto the screw shanks to secure it in place.Leave a gap (~ ¹/8th inch (3.2 mm)) between the screw heads and wall. Install the provided hardware (screws and wall anchors if necessary) but do not tighten the screws.Drill three holes at the marked locations.Use the TSP Template image on the last page of this guide to punch through and mark all three mounting keyholes on the wall (the top hole cannot be accessed through the TSP housing).The latch is magnetic, use the finger tabs on both sides and pull back from the housing to open (see Fig. The two lower keyholes can be accessed by opening the lower front cover of the housing. Mount the TSP60 using the three mounting keyholes at the rear of the unit.Connect the other end of the power cable to an electrical outlet. Connect the power cable and the HDMI cable to the monitor (see Fig.Note: HDMI 2 is for the Drive-Thru Leaderboard display (if desired). Connect the HDMI cable for the primary monitor to the port labeled HDMI 1.Connect a mouse (and keyboard if desired) to the USB port (see all connections in the following diagram).Connect the network cable to the network port (verify it is also connected at the network router end).Note: The HME Sales and Service sticker should be right-side up. Mount the plated CU to the wall using the necessary hardware (screws and wall anchors if necessary) see Fig.Hold the plated CU against the wall, and mark the wall through the four outside mounting holes.Attach the CU to the CU wallplate using the provided hardware (see Fig.Attach the monitor to the faceplate with the provided hardware (see Fig.Mount the bracket to the wall using the necessary hardware (screws and wall anchors or toggle bolts if necessary) see Fig.Hold the wallplate level against the wall, and mark the wall through the two mounting holes.To do this, find an appropriate location (preferably along with a stud if the wall construction is a wood stud frame). Mount the monitor bracket to the wall.Remove (if attached) and discard the monitor base stand (see Fig1.2).Mount the system high enough on a wall to be out of the way but still visible/accessible.Clearance from obstructions like electrical and plumbing obstructions when drilling.Cable lengths required between connections.Appropriate space for mounting all system components.Survey the premises with the store manager to determine the optimal mounting location for the ZOOM Nitro.Check the packing list! Verify you have received everything listed.
0 kommentar(er)
